Today we bring 488nm single-mode fiber laser module. This is a modular structure, and the desktop model can also be customized. The laser output power can be adjusted, and the adjustment range is 10% ~ 100%. The laser can be controlled by software, connected to the computer via RS232-USB. This laser adopts semiconductor laser chip, ...
The following is a demonstration of the operation of the desktop YDFA button control. Let’s check it now. This is a 50mW Ytterbium Doped Fiber Amplifier with PM Fiber. The working wavelength is 1030nm~1070nm. It supports ACC and APC working modes. We can switch the APC/ACC working mode with the left and right buttons. At ...
This is a wavelength tunable fiber laser, packaged in a module. It use SM single-mode fiber, PM polarization-maintaining fiber can be customized. It controlled by software. If the software is opened, the Portlist is blank, and COM** cannot be found. Please check whether USB port driver on your computer is working properly. The adjustable wavelength ...
It is a 980nm 20W fiber coupled laser with adjustable power supply. 20W is very high power, we added a radiator at the laser bottom and the radiator includes two cooling fans. There are CW/TTL/Analog 3 working mode for this laser system. The fiber is 600μm multi-mode fiber with SMA905 interface. Installation introduction: 1. Connect ...
This is 532nm 5W fiber coupled laser. It is a customized laser. Customized features is this laser system will output a low-power guide red laser before high-power green laser output. Add a modulation signal DC 0-5V, anlog modulation can adjust the 532nm laser’s output power. This test, we add 3.7V and we can get near ...
It’s a 808nm 10W high power infrared fiber coupled laser. This 808nm laser system includes a laser head, a power supply, a fiber, a collimator. There are CW, TTL, Analog 3 working mode can be choosen. And the focal length of collimator is adjustable. Let’s check it now.